A Slashdot user posed a question: how to conclusively destroy 15-some hard-drives without spending big bucks on a degausser or wasting a lot of time waiting for DBAN to run. I like this response from Plover (who also recommends protective gear):
If you're looking for fast production-line destruction, take a three pound hammer and punch. A punch driven through the aluminum plate covering the platter section, midway between the center spindle and the edge of the drive, down to the bottom of the case through the platters, will effectively destroy the disks. It will cheaply render the data unreadable to anyone who doesn't want to invest ten thousand dollars investigating the remains of the disks. You can crank through many disks per hour. A 3/8" bit in an electric drill would be similarly effective, and less labor intensive than a hammer, but slower…
But with 15 drives, it's just not that big of a job. Why make a big mess? Disassemble them. It takes about 10 minutes per drive, and it's both educational and fun. You can probably do it watching TV on the couch.
A miniature Torx driver set (T6-T9, available from Sears), a flat bladed screwdriver, a #2 Philips screwdriver, and a pocket knife is all I need to take most drives apart down to their components. Recover the voice coil driver magnets, they're always useful. Remove the circuit boards and recycle them as they were probably soldered with lead. Remove the platters from the spindles. To truly be rid of the data, you'll have to basically destroy the platters in a very hot fire. Heating them past their Curie point will completely destroy the data, leaving them totally unrecoverable; but that may require heat as high as 1500 degrees F. You won't get that on a stovetop.
(Image: Hard Drive 016, a Creative Commons Attribution (2.0) image from jon_a_ross's photostream)
